The front bumper isn’t securely attached on one side. When I push it back into place, it keeps popping out after a few minutes. Can I fix this without replacing any parts? If not, what’s the best and easiest solution? I think this issue is from a rear-end accident I had earlier.
Have you checked if a clip might be missing or if there’s another issue causing the problem?
I’d look for any clips or screws that hold the bumper in place, aside from the tabs. I’d remove them, reposition the bumper, make sure the tabs are fully secured, and then put the clips or screws back on.
I’ll do that in morning, thx
Get some zip ties will do just fine
I’ts 2018 se hatch by the way
Double sided tape in between the trim not so sure though
I’ll try if that helps it’ll hold it up tho thx
You could try using black silicone for the engine block and a floor jack to apply pressure. Let it sit overnight and see if that helps.
Yup this does sound great. It’s plastic so it’s likely to work
Will look into that thx
Mine is held on with zip ties, maybe some duct tape, and the last of my hopes and dreams.
Alright thank you
Mine did the same thing. I just tapped it back into place with my palm.